LotusElan.net Unified Search
Search results for: replacing engine in category "Electrical / Instruments"
685 results found containing all search terms.
46 pages of results.
Sorted by relevance / Sort by date
166. Lumention Ignition - Which bit breaks? : Electrical / Instruments - Page 2 by LotusElan.net [Electrical / Instruments]
So why doesn't everyone fit Lumention?????? I've heard of lots of problems with 123 or whatever it is?
... kept their setting and any checking or replacing has been when I've got the carbs ... or doing something else to the engine so there's been minimal additional effort. I ...
167. 1969 S4 - replacing old behind dash wiring (doh!) : Electrical / Instruments - Page 2 by LotusElan.net [Electrical / Instruments]
Hi folks - well, I've finally had time to start to tackle the wiring replacement task that I reached to out everyone for feedback and ...
... 1969 S4 - replacing old behind dash wiring (doh!) Hi folks ... multi-pin connector between the dash harness & engine bay harness, rather than the multitude ...
168. vacuum for distributor...where? : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Where is there a suitable vacuum port on a TC engine for the vacuum advance on my new distributor? I attached a hose to the ...
... CBUEB1771 To clarify. I wanted to replace my original distributor in an attempt to ... a suitable vacuum port on a TC engine for the vacuum advance on my new ...
169. vacuum retard port with stromberg carbs : Electrical / Instruments - Page 2 by LotusElan.net [Electrical / Instruments]
John, how did you shift the advance curve? Did you just go with a euro dizzy or petronix?
... euro dizzy or petronix? chickenstock10k I replaced the stock distributor and Pertronix Ignitor with ... were the final steps in converting the engine to non-Federal spec. The 123 Ignition ...
170. New BIGGER battery : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Hi everyone, As the title suggests I'm after a new battery for my plus 2.The one I'm using now is a NUMAX type 015. Rated ...
... local Halfords to see about a direct replacement but they don't have one that's same ... the dash before it goes into the engine bay / solenoid. It also acts ...
171. Ambient temp gauge : Electrical / Instruments - Page 2 by LotusElan.net [Electrical / Instruments]
Sounds like removing the dashboard will entail an engine out job so that the capillary tube can be taken out with as little disturbance as ...
... coincide with swapping the dash out and replacing all the grommets. (By the ... like removing the dashboard will entail an engine out job so that the capillary tube ...
172. Loads Of Trouble Usually.... : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
My +2 refused to start earlier in the week, with the starter solenoid making chattering clicking noises.. Oh dear I thought, this is sudden - ...
... with a bit of emery cloth. Replace fuses - engine starts first time. ... - success the starter runs and the engine starts and runs happily. Stop engine ...
173. Stubborn misfire : Electrical / Instruments - Page 2 by LotusElan.net [Electrical / Instruments]
Thanks, mbell - shame it doesn't show the other end of the resistor (or label it explicitly). Mazzini, I suspected this might be the problem ...
... still have an issue. Did you replace the coil HT lead completely or just ... at all, being mounted on the engine the whole thing must get quite hot ...
174. Fuse box location Plus 2 : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Hi All; Stupid question, but where is the fuse box located on a 1970 Plus 2? I just picked up yet another Lotus and the ...
... completely compromised, I would recommend just replacing the whole loom. HTH Stu stugilmour ... was disconnected. I looked in the engine compartment and under the dash with no ...
175. Alternator Pulley : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Dear All Back from two weeks in Corfu and ready to go........before I went my battery failed (I think-still have to test it) but while ...
... equipped + 2. I ended up replacing the alternator pulley (appox 80 mm ... enough to charge the battery when the engine is at idle , ie it's output ...
176. Ignition Wiring : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
I recently managed to fry the module in the Petronix ignition (my own fault, but we won't go there) and want to change back (temporarily) ...
... now. I expect that you simply replace the pertronix with the original contacts, ... Flamethrower distributor for my Lotus Twin cam engine - unfortunately I will have replaced my ...
177. How to test electric oil pressure gauge? : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
During a recent drive I noticed that the oil pressure gauge was pegged at zero (and the needle was vibrating a little), but since the ...
... read battery voltage. You could also replace the sensor resistance with an appropriate fixed ... a little), but since the engine was making no evil noises and I ...
178. Gauge issues : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
When I got my car it had a replacement Smiths temp/pressure gauge in it. That gauge quickly began to read low. So I bought a ...
... I got my car it had a replacement Smiths temp/pressure gauge in it ... I further pointed out that as an engineer/physicist I had skillfully worked on ...
179. Current : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Hi, My early +2 has had an alterator conversion, but retained the ammeter (upgraded to +-60Amps). Everything appears to be OK, I *think* the battery ...
... . Is this correct? I originally replaced the +-30 unit with the +-60 because ... ! With the lights on and the engine not running, it moves slightly negitive ...
180. Ignition warning light : Electrical / Instruments - Page 2 by LotusElan.net [Electrical / Instruments]
Hi All One possible explanation for the ignition light stays on then a blip of the engine to 1500rpm and it goes out then (maybe) ...
... bulb. That said I would just replace the lamp for the standard specification initially ... stays on then a blip of the engine to 1500rpm and it goes out then ...
Search took 0.130 seconds