LotusElan.net Unified Search
Search results for: cv shafts in category "Drive Train / Gearbox / Final Drive"
309 results found containing all search terms. 862 results found containing some search terms.
79 pages of results.
196. lotus 5 speed propshaft length : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
I have a 5 speed propshaft that looks like it has been shortened to put in a baby elan, I need to lengthen it for ...
... AussieJohn John, Info from John Clegg some time ago said: "My plus2 shaft is 33 1/2 " between u/j centres" John's information ...
197. Diff re-seal : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
Now that I've driven the Plus 2 a few hundred miles since getting it back to operability, I'm fairly certain that the diff is leaking. ...
... to check during the job? The Veg Veg If its leaking from the drive shaft bearings this can be done insitu, if however its from the diff to ...
198. Driveshaft weights and loctite : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
First can someone tell me the weight of: MM CV Driveshafts please. Also the weight of Driveshafts with UJs. Last question on the MM CV ...
... tell me the weight of: MM CV Driveshafts please. Also the weight of ... screw then got bent when the Drive Shaft flopped about. bringing the + 2S ...
199. Diff Unit Leaking Oil : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
This is not an uncommon problem, but want some advice on what to do when I get it out and on the bench. This car ...
... that is reasonably accurate based on the known history. Was planning to replace input shaft oil seal, two output shaft oil seals, and diff housing gasket. ...
200. Soft thumping : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
I noticed a soft thumping noise on the road the other day, at wheel speed on my +2. You could hardly hear it. It seemed ...
... wheel revolution. I now suspect the cv drive shaft, which has a few ... backlash and 60000 miles wear. Is there anything else that might be the cause ...
201. Driveshaft upgrade : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
Hi all. Me again, with another problem. I'm getting used to things not fitting though... good humour and a positive output is required. I'm trying ...
... from Sue Miller. They have a CV joint at either end, and studs ... them a bit tight Once fitted the shafts are excellent nebogipfel I've just re-measured the ...
202. Rear Hub Shafts : Drive Train / Gearbox / Final Drive - Page 2 by LotusElan.net [Drive Train / Gearbox / Final Drive]
Hi Mark, I fitted TTR keyless shafts, steel hubs and his special washer about 2 years ago to my S4 race car. I followed his ...
... Rear Hub Shafts Hi Mark, I fitted TTR keyless shafts, steel hubs and his special washer about 2 years ago to my S4 race car. I ...
203. Twin-Cam to T5 Bellhousing Anyone? : Drive Train / Gearbox / Final Drive - Page 5 by LotusElan.net [Drive Train / Gearbox / Final Drive]
In a previous message I said The rear mark labeled 'S10' is the location is the S10 shift lever location again assuming a stock Elan ...
... tower for the new Mustang's set-back shifter location and a harmonic damper on the output shaft. Looks like it might make an interesting alternative to the S10 tail housing ...
204. Knocking noise from gearbox/bellhousing : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
20 miles ago a knocking noise that varies in speed started in gearbox area - This noise is present in all gears and if clutch ...
... gears and if clutch pedal is depressed - knocking noise stops. I disconnected drive shaft and ran engine / gearbox to eliminate driveshaft etc and same knocking phenomenon detailed ...
205. differential rebuild : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
My S3 has a loud differential whine so I purchased a used 3.55 unit to install in its place. Since I must replace the pinion ...
... owners cut these pins off when fitting CV joint axle conversions. CBUEB1771 Agree the ... each other but both have the reduced shaft. The spline lengths are also different ...
206. uprated diff output shafts : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
I recently acquired a pair of uprated Lotus diff output shafts for my Elan in anticipation of boosting engine HP to about 140-150. Shaft increase ...
... output shafts supplied as part of his CV joint system. I did not ask ... uprated diff output shafts I recently acquired a pair of uprated Lotus diff output ...
207. Drive shaft central pins : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
Hi All I am ready to fit drive shafts. I have 2 options from my box of parts Pair of Rotoflex but need new rubber ...
... monumental debate about the do nuts, CV and hook joints. This is what ... Drive shaft central pins Hi All I am ready to fit drive shafts. ...
208. The old "While its out what else should I do" post REAR END : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
Other related post here is here: elan-f14/rear-diff-removal-and-jackstand-placement-t22593.html Short version - inner rear axle broken - differential unit has been removed and awaiting benchwork. Owner chooses ...
... The owner is going for the new CV type axles and tossing the old rubber ... the effort to have the prop. shaft taken out and inspected , balanced , ...
209. Bloody gearbox! : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
OK gearbox is on the bench. I pulled the nose piece ( the bit inside the bell housing) to replace the seal. Unbeknownst to me, ...
... seal. Unbeknownst to me, as it came off it pulled the main drive shaft/ bearing out about ?? . Having never used this gearbox I thought ...
210. Hub removal : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
I'm replacing rear axle bearings and cannot separate one of the hubs from the axle. I have researched the subject here as well as having ...
... cast steel. I have used PB blaster penetrating oil behind the hub into the shaft and let it set for a day, then applied the puller and the ...
Search took 0.149 seconds