LotusElan.net Unified Search
Search results for: cv shafts in category "Misc."
2 results found containing all search terms. 15 results found containing some search terms.
2 pages of results.
Hi, It would appear that my 73 +2S 130/5 was one of the cars that was built while some people were taking an extended lunch ...
... + 2 5 Speed prop shaft maintenance Hi, It would appear that my 73 + 2S 130/5 was one of the cars that was built while ...
I ran my Sprint without returning springs for a while many years ago and didn't notice any wear to speak of. Upon doing my full ...
... diff is overhauled and it's got the CV joints I fitted. So not much ... . I'll make sure I get the shaft properly home this time! Having had ...
If it helps you're making me feel a lot better about my decision just to refit the existing clutch in my car!
... they fit. vincereynard The Elite front cover will work with either type of input shaft bearing. No changes were made to the main casing when the bearing was ...
Hi, I've completed making the brackets and tested them (paint pending). I just thought you folks would want to see it. I experimented with having ...
... prone to failure. One additional thing I did, was position the motors armature shaft so it points upwards toward the engine compartment. Broached a piece of tubing ...
5. LotusElan.net at LotusElan.net [Misc.]
... Seals, Clips, Weather Strip Removing CV joints from stub axles Sports car no ... For Sale Gathercole special grind race cam shafts - c180bhp for sale FS: 1969 ...
In preparation for my intended swap from 4 to 5 speed gearbox in the Elan, can anybody provide templates or details of the alterations required ...
... the exact dimension from flange to flange, of the + 2 converted length Prop shaft ? Replies accepted with thanks, Regards, Phil. l10tus Phil Memory fading ...
I bought this car pretty much sight-unseen off of eBay 3 years ago. Everything was there, the chassis was good, and it ran. But there ...
... spring and saw hydraulic fluid all over the floor. - replaced the doughnuts with CV joints from DBE - replaced the stock radiator with the 26R version from DBE ...
8. Distributors : Archive by LotusElan.net [Misc.]
Can anyone tell if a Formula Ford 1.6L distributor is compatible with a Lotus twin cam? - Thanks - John
... fit the clamp and had th advance curve set to suit the Elan. The shaft may also have been machined to fit the drive gear but I cannot confirm ...
Now the gearbox is out of the car, it's time to apply a little bit of Vince Reynard magic to the gear change. There are ...
... to grind it down a little as the M10 die would not go round the shaft - too fat. So there we are. Hopefully a much improved gearshift ...
Hi! Recently, the reverse shift folk always comes off when I tried to back my Elan S4 1969 Does anyone know the cause? It wouldbe ...
... gear lever will stop it from jumping out of the groove in the relay lever shaft. Good luck. Edit...I have just found a reference to the pin in a ...
my car came with a generic (cortina) wiper switch and a pushbutton washer pump pusher - i don?t drive in the wet BUT ev ery ...
... . But there is a ?thrust screw? for one end of the armature shaft. The motor runs in the direction in which the armature ?screws? ...
Anybody have any experience with lightweight flywheels, either aluminum or turned down? I use the car mostly for autocross with occasional street driving.
... still had the original non-Sprint doughnuts; but I got rid of those and have CV joints now. Best modification that improved driveability I've done on the car! ...
Hi all, Well, I burned out the rubber and inner race. But the now how do I get out the outer shell? I have tried ...
... mean the bolts that secure the lotocones to the chassis and not the shock absorber shaft? Mine is a coupe and I found it necessary to carefully take out ...
14. 5-Speed Candidate Conversion Chart : Drive Train / Gearbox / Final Drive by LotusElan.net [Misc.]
Picking up on the encouragement of David aka msd1107, I reorganized and expanded the transmission chart I posted in the Elan - Isuzu 5-speed thread. ...
... 4-speed. It would seem that a shop that can cut gears could take the shafts and gears from a donor gearbox, and cut a new set to our ...
Late federal Elan Sprint DHC My horn works great.....except when the steering wheel is dead center, which is the ideal position while driving straight down ...
... column just above flexible joint to the rack mounting earth.. Etc. The column shaft itself is the Conductor. I hope this makes sense wotsisname This pic shows the ...
Search took 0.134 seconds