Recommendations for wiring looms
17 posts
• Page 2 of 2 • 1, 2
Thanks all for the good advice and the sharing of your experience and information. Really useful.
If all goes to plan I will be passing Autosparks next week so planning on dropping in for a chat....
Another PM's visit already on the cards for other bits and bats so will see what we end up with loom wise.
Anything is likely to be an improvement on the existing break If You do much as look at it cables...
One other thing that I am looking to do is improve on the earth paths.
Although it may not fit with the adding lightness philosophy I have been toying with running an ancillary earth cable front to rear and tapping in to this directly rather than rely solely on the frame.Regards
Thanks again
Regards
Mel
If all goes to plan I will be passing Autosparks next week so planning on dropping in for a chat....
Another PM's visit already on the cards for other bits and bats so will see what we end up with loom wise.
Anything is likely to be an improvement on the existing break If You do much as look at it cables...
One other thing that I am looking to do is improve on the earth paths.
Although it may not fit with the adding lightness philosophy I have been toying with running an ancillary earth cable front to rear and tapping in to this directly rather than rely solely on the frame.Regards
Thanks again
Regards
Mel
- Sploder90
- Second Gear
- Posts: 200
- Joined: 09 Apr 2019
17 posts
• Page 2 of 2 • 1, 2
Total Online:
Users browsing this forum: No registered users and 26 guests