Lotus Elan and Lotus Elan Plus 2 Forums

Anyone changes the bezels on a 2" Smiths gauge?

I'm looking to convert gauge with a bevelled bezel to a flat bezel to match my existing gauges. I bought a flat bezel online but the depth of the bezel is only 2.45mm compared with 3.1mm on my other gauges and I suspect that the tabs won't be long enough to bend over the gauge. Looking at the Auto Electrical Spares website, they also show the depth of their (out of stock) part as 2.5mm.

Have actually tried to fit it? Half a mil difference it might go on. Otherwise you could take out the rubber and use a thin sliver of silicone instead.

Hi Steve,
Not tried yet, partly because another thread said that it won't fit. I'll try taking the existing bezel off tomorrow. Even if it does fit, the gauge will sit closer to the dash than the other gauges as the bezel is shallower. 0.5mm may not seem much but it looks a lot when you put the bezels next to each other.

You could always fit a black band around the outer case which wouldn’t be seen and would have the gauge stick out a little. I honestly don’t think you of anyone else would notice.

I got several bezels through Moss and Nisonger I’m pretty sure, Gordon