Brake Servo Bracket Holes
Posted: Fri Nov 07, 2014 8:46 pm
As part of my Plus 2 rebuild a new nose section has been fitted but without any of the holes. I do not have the original nose section for reference and would therefore welcome help please to correctly locate the four holes to mount the original Girling MkIIB servo.
There are a couple of options but all assume the servo is not fitted to allow access;
1). I have produced a sketch of the triangular section of the inner wing with letters A to H for the actual dimensions required. If these could be provided that would be a great help.
or
2). Can anyone take a photo square on the the panel so I can use the known distance between the holes to scale off.
or
3). Any takers for a good old 'brass rubbing' approach?
To finally clarify, should the servo body end up square to the engine/chassis centreline?
Hope this is not too much of a problem but I am keen to do the job right!
Regards
Gary
There are a couple of options but all assume the servo is not fitted to allow access;
1). I have produced a sketch of the triangular section of the inner wing with letters A to H for the actual dimensions required. If these could be provided that would be a great help.
or
2). Can anyone take a photo square on the the panel so I can use the known distance between the holes to scale off.
or
3). Any takers for a good old 'brass rubbing' approach?
To finally clarify, should the servo body end up square to the engine/chassis centreline?
Hope this is not too much of a problem but I am keen to do the job right!
Regards
Gary