Repaired steel wheels / refurb / Minilites
Posted: Wed Sep 26, 2012 11:30 am
I just spent a couple of days wire brushing and priming my old steel wheels, luckily found an old Ikea sink as a wheel mask!
Anyway wheels as follows
No 1 - OK
No 2 - OK
No 3 - Peg holes slightly enlarged
No 4 - Rim welded + large dent
No 5 - Peg holes very enlarged
The question is what is acceptable, also I am going to be using TTR rear UJs , would alloys be better suited?
Any advice gratefully sought!
Thanks
George (4th)
Anyway wheels as follows
No 1 - OK
No 2 - OK
No 3 - Peg holes slightly enlarged
No 4 - Rim welded + large dent
No 5 - Peg holes very enlarged
The question is what is acceptable, also I am going to be using TTR rear UJs , would alloys be better suited?
Any advice gratefully sought!
Thanks
George (4th)