Parking brake dash light bulb replacement
7 posts
• Page 1 of 1
Ken,
If its just the normal round warning light on the dash, the fitting is just pushed in from the front of the dash and the bulb & bulb holder is then pushed into the fitting from the rear, pull on the bulb holder from the rear and it should come out complete with bulb,holder & wires.
Brian
If its just the normal round warning light on the dash, the fitting is just pushed in from the front of the dash and the bulb & bulb holder is then pushed into the fitting from the rear, pull on the bulb holder from the rear and it should come out complete with bulb,holder & wires.
Brian
Brian
64 S2 Roadster
72 Sprint FHC
64 S2 Roadster
72 Sprint FHC
-
types26/36 - Coveted Fifth Gear
- Posts: 3873
- Joined: 11 Sep 2003
Yes, the clyinder of black plastic is part of the front lens,the bulb holder pushes into the black plastic tube, just tug on the wires as its difficult to grip the bulb holder.
Brian
Brian
Brian
64 S2 Roadster
72 Sprint FHC
64 S2 Roadster
72 Sprint FHC
-
types26/36 - Coveted Fifth Gear
- Posts: 3873
- Joined: 11 Sep 2003
Klev, If it is the little bayonet type I had no trouble sourcing them from the ususal suspects(dave Bean in my case). Actually I had no trouble getting ANY of the lamps for the dash/fascia indicators or instruments.
Mike Geiger
66 S3 Coupe', no more
66 S3 Coupe', no more
-
type36lotus - Fourth Gear
- Posts: 564
- Joined: 17 Sep 2003
7 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 28 guests