Thackeray to Bobbins
3 posts
• Page 1 of 1
Post by: Breezehill » Thu Sep 08, 2022 1:10 pm
Apologies if this has been answered but couldn’t find a thread.
Following a refurb on the Weber carbs they are being refitted using the later cup and rubber bobbins.
What gap should you go down to between the cups when fitted?
Following a refurb on the Weber carbs they are being refitted using the later cup and rubber bobbins.
What gap should you go down to between the cups when fitted?
-
Breezehill - Second Gear
- Posts: 83
- Joined: 09 Oct 2019
Post by: elans3 » Thu Sep 08, 2022 3:06 pm
I have mine set at around 0.025", and have been fine for 2 years since they were last off.
Current :- Elan S3 DHC SE S/S 1968,
1963 Alfa Giulia Ti Super Rep.
Previous :-
Elan S3 DHC SE SS 1968,
Elan S3 DHC S/E 1966
Elan S3 FHC Pre-Airflow 1966
1963 Alfa Giulia Ti Super Rep.
Previous :-
Elan S3 DHC SE SS 1968,
Elan S3 DHC S/E 1966
Elan S3 FHC Pre-Airflow 1966
- elans3
- Third Gear
- Posts: 462
- Joined: 12 Sep 2003
Post by: Breezehill » Thu Sep 08, 2022 3:38 pm
Thanks for getting back
-
Breezehill - Second Gear
- Posts: 83
- Joined: 09 Oct 2019
3 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 18 guests
Site map
SitemapIndex
RSS Feed