Access to O ring at rear Stromberg float bowl
Posted: Sun Aug 19, 2018 11:06 pm
Does anyone know if I can access the rear Stromberg Carburetor Jet Cover O ring without removing the Rear Carburetor from the manifold? I want to remove the plug w O ring and replace the O ring since it was weeping.
Can you detach the motor mounts and possibly the transmission mount, then lift the motor high enough for the bottom of the rear carb to clear the footwell and remove the Jet Cover on a LHD?
Another question is why the fuel pump is so close to the footwell, about 1/8" clearance? Failed motor mounts ?? About 28 years old, low mileage of course. Both motor mounts look the same, so no mix up as required for webers.
TIA!,
Brad
Jet Cover
Stromberg Float Bowl
Fuel Pump Clearance
Motor Mounts:
Left Mount
Right Mount
Can you detach the motor mounts and possibly the transmission mount, then lift the motor high enough for the bottom of the rear carb to clear the footwell and remove the Jet Cover on a LHD?
Another question is why the fuel pump is so close to the footwell, about 1/8" clearance? Failed motor mounts ?? About 28 years old, low mileage of course. Both motor mounts look the same, so no mix up as required for webers.
TIA!,
Brad
Jet Cover
Stromberg Float Bowl
Fuel Pump Clearance
Motor Mounts:
Left Mount
Right Mount