Page 1 of 1

DCOE Mounting Flange Query

PostPosted: Thu Sep 04, 2014 2:52 pm
by AlfaLofa
I have a pair of DCOE31s which I have (nearly) dismantled.

I have now just noticed that a couple of the mounting holes have been enlarged.

Should I have them drilled and sleeved?

Or

Will they be ok as they are?

Re: DCOE Mounting Flange Query

PostPosted: Fri Sep 05, 2014 3:35 pm
by wgrainge
Sometimes the mounting bolts on the manifold aren't aligned quite perfectly, and the Weber holes have been elongated slightly so that the carbs doesn't bind on them. I don't know if this is considered acceptable practice or not, but I've come across it before. Personally, I don't think it's anything to be concerned about.

-Will

Re: DCOE Mounting Flange Query

PostPosted: Fri Sep 05, 2014 3:45 pm
by RogerFrench
Since you're going to have a couple of O-rings between carb and manifold, and the carb is flexibly-mounted in any case, I don't think it matters.