Easy weber mixture tool

Post by: **twincamman** » Sat Oct 12, 2013 9:39 pm

Buy a remote thermometer , the one with the lazer beam ...focus on each runner and match the temperatures by setting the mixture and balance screws ......Ed

Post by: **ncmarc** » Sun Oct 13, 2013 3:43 am

what's a "runner" ?

Post by: **twincamman** » Sun Oct 13, 2013 4:06 am

The round tube that RUNS from the exhaust port to the collector. There are 4 measure each one ..they should be the same temp as the gas runs through them

Post by: **rcraven** » Sun Oct 13, 2013 9:32 am

What's a "collector"?

Post by: **Pistacchio sprint 72** » Sun Oct 13, 2013 11:24 am

The piece of tube gathering the 4 exhaust tubes attached to the head

Post by: **twincamman** » Sun Oct 13, 2013 4:49 pm

What's the use

Post by: **alexblack13** » Sun Oct 13, 2013 5:08 pm

What's your experiences using a remote thermo? Happy? What make model? etc.

I have one but have never used it on the TC engine. Will try it later. :wink:

Thanks for the heads up.

AB...

Post by: **KevJ+2** » Sun Oct 13, 2013 6:09 pm

This is such a great thread, I haven't laughed so much in ages :lol:

Post by: **Pistacchio sprint 72** » Sun Oct 13, 2013 6:46 pm

Ok, i always wanted to know but never dare to ask... If that?s a thermometer on my ear where is my pencil?

Post by: **billwill** » Sun Oct 13, 2013 6:48 pm

twincamman wrote:The round tube that RUNS from the exhaust port to the collector. There are 4 measure each one ..they should be the same temp as the gas runs through them

Is "runner" Canadian for what USA people call "headers" and UK people call "Exhaust Manifold" ?

Post by: **Galwaylotus** » Sun Oct 13, 2013 7:00 pm

I believe the assembly of runners and collector is the exhaust manifold. :wink:

Post by: **Galwaylotus** » Sun Oct 13, 2013 7:03 pm

BTW, it's the relative temperature of the runners that's important here so even if the emissivity is not spot on, the relative temperatures should still be valid - assuming there's a similar amount of rust on each tube in the exhaust manifold! :wink:

Post by: **alexblack13** » Sun Oct 13, 2013 8:20 pm

emissivity ...... ;-)

Not a bad word for a Sunday by the way...

Al' ....

Post by: **elanner** » Sun Oct 13, 2013 8:31 pm

That's cool (well, hot). I've never heard them referred to as runners or collectors.

But then I'd never heard of headers either until I arrived in the US.

And I thought a Fender was a guitar. And don't get me started on rocker panels. ;-)

Nick

Post by: **twincamman** » Mon Oct 14, 2013 3:37 am

Oiiiiiii....runners make headers ...that run into 4 into 2 into 1 collectors and that runs into the exhaust tube ........and that's attached to the rib bone....this causing me exhaustivity

Easy weber mixture tool

Total Online:

Recent Forum Topics

Support LotusElan.net!

Recent Wiki Articles