Calculate compression ratio from compression tester result
7 posts
• Page 1 of 1
Hi
Bit of a technical one, this.. Can the Twink's compression ratio be worked out (even approximately) from the readings taken from a compression tester?
For example, I measured 192, 196, 199, 210 PSI respectively in a cold crank test (albeit with the throttle closed) for cylinders 1,2,3,4 respectively. Is there a formula for calculating the compression ratio from these?
Ta muchly
JonB
Bit of a technical one, this.. Can the Twink's compression ratio be worked out (even approximately) from the readings taken from a compression tester?
For example, I measured 192, 196, 199, 210 PSI respectively in a cold crank test (albeit with the throttle closed) for cylinders 1,2,3,4 respectively. Is there a formula for calculating the compression ratio from these?
Ta muchly
JonB
-
JonB - Coveted Fifth Gear
- Posts: 2498
- Joined: 14 Nov 2017
- Location: South Herefordshire
I'd say it would be hard to get an accurate compression ratio figure - different cams will give different readings, cam timing and even small things like how loose or tight cam/valve clearance figures are will make a difference. Piston ring sealing will also vary results so it would be an educated guess.
Last edited by promotor on Wed Sep 27, 2023 9:14 pm, edited 1 time in total.
-
promotor - Fourth Gear
- Posts: 831
- Joined: 16 Mar 2012
- Location: Derbyshire, U.K.
-
john.p.clegg - Coveted Fifth Gear
- Posts: 5767
- Joined: 21 Sep 2003
- Location: Manchester
Thanks John, very useful. I'm figuring something like 10.5:1 ratio but I will do another test once the engine is running.. in about 100 years at this rate...
-
JonB - Coveted Fifth Gear
- Posts: 2498
- Joined: 14 Nov 2017
- Location: South Herefordshire
That's a cracking document. Very interesting.
Elan +2
Elise mk 1
Elise mk 1
- Donels
- Fourth Gear
- Posts: 728
- Joined: 10 Sep 2016
- Location: Tamworth
If I remember correctly the standard compression ratio for a lotus twin cam of your cars vintage is 9.5:1
No doubt those with more definite knowledge will be along shortly. 10.5:1 would be a modified/uprated engine
No doubt those with more definite knowledge will be along shortly. 10.5:1 would be a modified/uprated engine
Kindest regards
Alan Thomas
Alan Thomas
-
Spyder fan - Coveted Fifth Gear
- Posts: 2873
- Joined: 11 Jun 2009
- Location: Kent country & Sussex seaside UK
Interesting, Alan. It's an S/E engine with a D cam. I've seen these engines referred to as "Super S/E".
-
JonB - Coveted Fifth Gear
- Posts: 2498
- Joined: 14 Nov 2017
- Location: South Herefordshire
7 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 16 guests