Head bolt recession - advice welcomed

PostPost by: dunclentdr1 » Sat Jan 30, 2021 4:32 pm

I was recently given a big valve twin cam of unknown history.

Upon inspection there is head bolt recession and in two place small splits in the metal close by.

I would welcome advice on this please, particularly on fixes.

Overall the head seems in good condition apart from this.

Thanks

David
Attachments
IMG_20210130_154219_resized_20210130_042819613.jpg and
IMG_20210130_154229_resized_20210130_042820103.jpg and
dunclentdr1
Second Gear
Second Gear
 
Posts: 178
Joined: 15 Jun 2017

PostPost by: rgh0 » Sat Jan 30, 2021 11:32 pm

With that amount of recession the head is almost certainly too soft to reliably use. Have a look at the head face and see if there is an indentation where the head gasket fire ring seats as that is another indication of a very soft head.

Its possible to fit steel inserts to repair the damage from the bolt recession but generally not worth the cost as the soft metal in the head will continue to deform and not seal the head gasket.

Get the head hardness tested before doing anything with it.

cheers
Rohan
User avatar
rgh0
Coveted Fifth Gear
Coveted Fifth Gear
 
Posts: 8815
Joined: 22 Sep 2003

PostPost by: knockoffnut » Thu Feb 04, 2021 6:09 pm

This reminds me of the mechanic who used a big impact wrench to torque down wheel bolts, and then put a torque wrench on the bolts, pulled to listen for the click and then said "see they are good"...
1963 Unicorn
1964 S1
1965 S2
1967 S3 SE DHC
Frankentwincam 26R
Seven S2 A
Seven S2 F
knockoffnut
Third Gear
Third Gear
 
Posts: 227
Joined: 02 Sep 2011

Total Online:

Users browsing this forum: 69S4 and 27 guests