Removal and rebuilding of a Twincam
Posted: Mon Apr 13, 2020 11:53 am
Just restarting this thread in the right section !
Having had an engine internal problem causing loss of power at my last race I decide to pull the engine to investigate. It would still run without any abnormal noises or smoke but the engine is partially seized and very hard to turn over by hand and that internal drag is clearly the cause of the loss of power. I have started this thread to record both the removal process, the rebuild and re-installation. Will post more when I get a chance. The engine came out today and tomorrow I hope to open it up to find out more.
cheers
Rohan
Having had an engine internal problem causing loss of power at my last race I decide to pull the engine to investigate. It would still run without any abnormal noises or smoke but the engine is partially seized and very hard to turn over by hand and that internal drag is clearly the cause of the loss of power. I have started this thread to record both the removal process, the rebuild and re-installation. Will post more when I get a chance. The engine came out today and tomorrow I hope to open it up to find out more.
cheers
Rohan