Page 1 of 1

Needle bearing fitment

PostPosted: Wed Mar 20, 2019 9:55 am
by how_lotus
Hi,

Can anyone tell me how far a new needle bearing should be pressed into the rear of the crankshaft? I can't find anything in the manual and there appears to be plenty of room to press it in too far? Or does it not matter?

Howard

Re: Needle bearing fitment

PostPosted: Wed Mar 20, 2019 10:14 am
by jono
I've just checked a crank that came out of a virgin TC and the bearing is around 5mm below the flywheel mounting face of the crank.

Re: Needle bearing fitment

PostPosted: Wed Mar 20, 2019 6:07 pm
by how_lotus
Thanks for checking that, I have it in ok.

Howard