43d4 Distributor Positions
Posted: Mon Mar 15, 2004 11:11 pm
further to my other posts I have now stripped back my carbs and pulled the distributor to discover that I have a 43D4 dizzy
for JackJabba the details are;
41471F
43D4 3091
according to the manual I need to reinsert the distributor with the pulley timing at TDC with the terminal facing the block and the electrode facing the rear cap mounting lug.
If I do this I cannot get the dizzy cap on as the outputs for the HT leads foul the inlet manifold.
Is there an accepted way to insert the 43D4 dizzy into the block to ensure that timing is correct ? (a picture of a 43d4 setup in a block would be nice !)
should my pulley mark actually be at 12 degrees BTDC for this insertion ? (i have established that the mark is true TDC)
guidance, as always gratefully recieved...
for JackJabba the details are;
41471F
43D4 3091
according to the manual I need to reinsert the distributor with the pulley timing at TDC with the terminal facing the block and the electrode facing the rear cap mounting lug.
If I do this I cannot get the dizzy cap on as the outputs for the HT leads foul the inlet manifold.
Is there an accepted way to insert the 43D4 dizzy into the block to ensure that timing is correct ? (a picture of a 43d4 setup in a block would be nice !)
should my pulley mark actually be at 12 degrees BTDC for this insertion ? (i have established that the mark is true TDC)
guidance, as always gratefully recieved...