Page 2 of 2

Re: Recommendations for wiring looms

PostPosted: Thu Aug 08, 2019 4:24 am
by Sploder90
Thanks all for the good advice and the sharing of your experience and information. Really useful.
If all goes to plan I will be passing Autosparks next week so planning on dropping in for a chat....
Another PM's visit already on the cards for other bits and bats so will see what we end up with loom wise.

Anything is likely to be an improvement on the existing break If You do much as look at it cables...

One other thing that I am looking to do is improve on the earth paths.
Although it may not fit with the adding lightness philosophy I have been toying with running an ancillary earth cable front to rear and tapping in to this directly rather than rely solely on the frame.Regards

Thanks again
Regards
Mel

Re: Recommendations for wiring looms

PostPosted: Sun Aug 18, 2019 5:52 pm
by lotusfan
Although it may not fit with the adding lightness philosophy I have been toying with running an ancillary earth cable front to rear and tapping in to this directly rather than rely solely on the frame.


A very wise move!!