Page 1 of 1
New wiring looms
Posted:
Sun May 11, 2014 12:25 pm
by William2
I am about to rewire my S4 and invest in wiring looms for the engine bay and dashboard. Has anyone had experiences of these from either Paul Matty or Susan Miller? Do they generally fit well with no alterations needed?
Re: New wiring looms
Posted:
Sun May 11, 2014 1:30 pm
by DavidLB
bought from susan miller for a +2s130. no problems
Re: New wiring looms
Posted:
Mon May 12, 2014 3:06 pm
by Lotus fan
Bought mine from here
http://www.autosparks.co.ukReally happy.
Re: New wiring looms
Posted:
Mon May 12, 2014 3:11 pm
by Mazzini
Bought an Autosparks loom for my '65 S2, it fits without issue.
Re: New wiring looms
Posted:
Mon May 12, 2014 4:20 pm
by TeeJay
Purchased my Dash, Engine bay and Rear looms from Paul Matty, for my 1968 +2. All fitted well.
So you have choice from several suppliers.
Re: New wiring looms
Posted:
Tue May 13, 2014 5:37 pm
by AHM
I Bought my S4 Engine bay loom from PM. The old one was for a Dynamo and the new one for a Lucas Alternator
Best price, fits well.
+ it has a feed and ground for the coil - useful if you have electronic ignition.
- it didn't have the short feed ( yellow /grey) wire for the air horn
Re: New wiring looms
Posted:
Wed May 14, 2014 4:08 pm
by William2
Do all new main harnesses come with the wiring for the side indicator wing repeaters as I notice they aren't shown on the S4 wiring diagrams??
Re: New wiring looms
Posted:
Wed May 14, 2014 9:57 pm
by AHM
the side repeater wiring is a bit of flat black flex that is soldered to the lamp.
You will need the 6 way bullet connector from your old loom for the ground. If you don't have one it is a 4 way with a 2 way soldered on to it.
Re: New wiring looms
Posted:
Fri May 16, 2014 10:09 am
by William2
Went to Paul Matty in the end as their cables were the best price.