wiring
Posted:
Sat Feb 26, 2011 4:07 pm
by rodlittle
Can anyone help me with some info, I have just made up a new loom for my S1 but I have no idea where or how it is fixed and the run it takes in the boot (trunk) What I have done is stick some triangular section pieces of wood up in the angle where the boot meets the tail and screwed it to them with cable clips, it works but is it right? and where does it go to connect to the fuel tank sender after leaving the right hand lights, above the boot floor, or below it?
Any help gratefully received
rod
Re: wiring
Posted:
Sat Feb 26, 2011 6:01 pm
by rodlittle
Thanks, as long as the S1 is the same as the S2 there then thats exactly what I needed
cheers
rod
Re: wiring
Posted:
Sat Feb 26, 2011 6:07 pm
by paddy
Re: wiring
Posted:
Sat Feb 26, 2011 6:22 pm
by rodlittle
Ahh thanks Paddy
looks like my wooden blocks are in the wrong position,
must try harder
cheers
rod
Re: wiring
Posted:
Sun Feb 27, 2011 12:15 am
by jk952
Thanks for the pictures and thread discussion connections, haven't done mine yet but getting close to that part, was looking for this kind of info since I wasn't the one who took the car apart...and likely would have forgotten routing details anyway....
Jack
65 S2