Page 1 of 1

Wiring Loom

PostPosted: Tue Aug 10, 2010 10:12 am
by graham
Can anyone help - where does front wiring loom on late 2S130 pass thru the bulkhead.
All holes in both sides have all been glased over so any photos showing all holes to both sides would be much appreciated.
Graham

Re: Wiring Loom

PostPosted: Tue Aug 10, 2010 12:31 pm
by innesw
Hi Graham,
The loom passes through the biggest hole just above and to the right (drivers side) of the heater pipes its a wee bit bigger than 3cm, if you need anymore photo's of specific areas just shout.
IMG_2192edit.JPG and

IMG_2196edit.JPG and

IMG_2195edit.JPG and


Innes

Re: Wiring Loom

PostPosted: Wed Aug 11, 2010 6:13 am
by graham
Thanks Innes Photos really helpfull.
Graham

Re: Wiring Loom

PostPosted: Sun Aug 15, 2010 1:34 pm
by innesw
Hi,
Here's the other photo as you wanted, the ambient temp "sensor" pipe actually exits from the most outboard hole on the drivers side and is routed down round the drivers side of the pedal box, if you understand me.

IMG_2203.jpg and


Rotate the pic 90 degrees counter clockwise as i can't upload it without resizing it again.

Innes

Re: Wiring Loom

PostPosted: Thu Aug 19, 2010 12:36 pm
by tcsoar
Hi Innes,

The last picture you posted above for the ambient temp. sensor pipe, is that not the drive for the windscreen wipers exiting through the passenger side?

Chris.

Re: Wiring Loom

PostPosted: Thu Aug 19, 2010 1:00 pm
by innesw
Yes chris that is the wiper motor rack, Graham asked for a picture of the passenger side for the location of the amb temp hole, I might have caused you some confusion as I put up the photo of the passenger side and then explained the hole isn't on that side... :lol:

Innes

Re: Wiring Loom

PostPosted: Thu Aug 19, 2010 1:29 pm
by tcsoar
Ahhhhhh, now I understand 8)

Re: Wiring Loom

PostPosted: Fri Aug 20, 2010 6:02 am
by graham
Thanks for the pict, I understood what you said
Graham