Lotus Elan

Replacing Ignition Switch

PostPost by: archigator » Sun May 21, 2006 9:28 pm

I'm replacing my Lucas ignition switch, part #39415 (the component that all of the wires connect to on the back of the ignition key switch.) How does this switch connect to the back of the key switch? On my car, the previous Owner connected it with masking tape! I can't see any way to connect it otherwise. Any help is much appreciated. Thanks

Gary
'71 Elan Sprint
Miami, FL
Attachments
Ignition Switch.jpg and
Last edited by archigator on Fri Jul 14, 2006 12:59 am, edited 2 times in total.
User avatar
archigator
Fourth Gear
Fourth Gear
 
Posts: 549
Joined: 15 Sep 2003
Location: Miami (down where the old gators play), Florida

PostPost by: ppnelan » Mon May 22, 2006 3:04 pm

Gary,

If it's the steering column lock type there should be a plastic 'tube thingy' that has one end big enough to clip over the lock body, a middle section that holds the switch itself, and a smaller diameter end that the wires pass through.

Mine is split but still has just enough 'hold' to keep the switch in place...

:arrow: Matthew
ppnelan
Fourth Gear
Fourth Gear
 
Posts: 734
Joined: 16 Sep 2003
Location: Norfolk, UK

PostPost by: twincamman » Mon May 22, 2006 6:44 pm

I moved the key to the dash and added a push button 'start ' switch --- real race car stuff --- :shock: ed---
Attachments
PB270004-1.JPG
PB270004-1.JPG (6.61 KiB) Viewed 1686 times
PB270004-1.JPG
PB270004-1.JPG (6.61 KiB) Viewed 1688 times
User avatar
twincamman
Coveted Fifth Gear
Coveted Fifth Gear
 
Posts: 2953
Joined: 02 Oct 2003
Location: Niagara falls [slowly I turned]

Total Online:

Users browsing this forum: No registered users and 7 guests