Page 1 of 1
Measurement needed on gear stick
Posted:
Fri Dec 13, 2019 7:55 pm
by gjz30075
Hi all. Can someone measure the distance from the top of the hemisphere of the gear stick to the
apex of the bend? If possible, also, what the angle of the bend is?
Thanks!
Re: Measurement needed on gear stick
Posted:
Fri Dec 13, 2019 10:38 pm
by SENC
Approximately 55 degrees, or 35 from vertical. Not sure exactly what dimensions you are seeking, but do the attached pictures help?
Re: Measurement needed on gear stick
Posted:
Sat Dec 14, 2019 12:18 am
by gjz30075
Henry, that close, thanks. Knowing the angle is helpful. Attached is a pic of the stick with a measurement needed between the two points shown.
Re: Measurement needed on gear stick
Posted:
Sat Dec 14, 2019 12:23 am
by SENC
Ah, you need the non-anti-sizzle version, too. Don't have one of those to measure.
Re: Measurement needed on gear stick
Posted:
Sun Dec 15, 2019 6:26 am
by Panda
My TTR gearstick which I am pretty sure is identical to the original one is 57mm
Alan P.
Re: Measurement needed on gear stick
Posted:
Sun Dec 15, 2019 2:18 pm
by gjz30075
Thanks Alan!