Page 1 of 1
Bell housing bolts
Posted:
Sun Feb 12, 2017 10:18 pm
by davidj
Hello.
Does anyone know the torque settings for the four gearbox/bell housing bolts? I cannot find any value in the workshop manual.
Thanks in advance,
David
Re: Bell housing bolts
Posted:
Sun Feb 12, 2017 10:45 pm
by p.faurie
F T
Regards phil
Re: Bell housing bolts
Posted:
Mon Feb 13, 2017 12:42 am
by mbell
There are some general torque numbers provided for each bolt size in the front of the manual. If one isn't specified you can use these as default values.
Re: Bell housing bolts
Posted:
Mon Feb 13, 2017 12:07 pm
by alan.barker
Reminder be sure to seal the bottom left bolt to stop leaks from the gearbox
Alan
Re: Bell housing bolts
Posted:
Tue Feb 14, 2017 12:20 pm
by davidj
Morning,
Unfortunately the general torque number are missing from my manual and I don't have a FT setting on my torque wrench! I think (from memory) they are 7/16 unc. Could someone please have a look for me.
Ta,
Re: Bell housing bolts
Posted:
Tue Feb 14, 2017 4:46 pm
by ericbushby
Technical Data section, Page 27, General Nuts and Bolts.
7/16 UNC.- 30-35 lbs/ft or 4.14 to 4.85 Kg/Metres
Eric in Burnley
Hope this helps
Re: Bell housing bolts
Posted:
Tue Feb 14, 2017 4:47 pm
by ElanDNA
davidj wrote:Morning,
Unfortunately the general torque number are missing from my manual and I don't have a FT setting on my torque wrench! I think (from memory) they are 7/16 unc. Could someone please have a look for me.
Ta,
Good evening
Your missing torque settings :
Urs
Re: Bell housing bolts
Posted:
Tue Feb 14, 2017 8:06 pm
by CBUEB1771
davidj wrote:I think (from memory) they are 7/16 unc.
These bolts are 3/8"-16 UNC, unfortunately I am away from my Workshop Manual so I don't know what Lotus gave as the general toque for these bolts. I was able to lay my hands on the Lotus Service Bulletin for installation of the Lotus five speed gearbox, no torque values given there!
Re: Bell housing bolts
Posted:
Thu Feb 16, 2017 12:29 pm
by davidj
Thanks very much Urs and Eric!
Re: Bell housing bolts
Posted:
Thu Feb 16, 2017 1:02 pm
by alan.barker
davidj wrote:Hello.
Does anyone know the torque settings for the four gearbox/bell housing bolts? I cannot find any value in the workshop manual.
Thanks in advance,
David
In Workshop Manuel Elan page 25 "Clutch housing to Gearbox"
40-45 lbs/ft
Alan
Re: Bell housing bolts
Posted:
Thu Feb 16, 2017 3:57 pm
by 1owner69Elan
Would the torque values be the same for a magnesium bell housing?