Lotus 5 speed dimension needed
Posted: Mon Jul 18, 2016 3:47 pm
I'm currently modifying a 4 speed gearbox mount bracket to fit my Lotus 5 speed. Mount should simply
be turned 180 degrees. When bolted up however, I think the gearbox sits too low. I've read that this
mount is a good alternative but it looks like it may not be totally correct.
I'm looking for the dimension of the gearbox shifter 'box' from the frame. Mine measures 1 3/16 inches.
To determine I'm too low, I measured the level of the block (of which I have a picture) with the car
on the ground. The frame is level, at this point.
A 'level' measurement of the block now, with the Lotus 5 speed and turned around 4 speed mount, shows
the block to be slanted too much downward at the rear.
So, if someone could take a measurement as shown in the pic, I'd appreciate it.
be turned 180 degrees. When bolted up however, I think the gearbox sits too low. I've read that this
mount is a good alternative but it looks like it may not be totally correct.
I'm looking for the dimension of the gearbox shifter 'box' from the frame. Mine measures 1 3/16 inches.
To determine I'm too low, I measured the level of the block (of which I have a picture) with the car
on the ground. The frame is level, at this point.
A 'level' measurement of the block now, with the Lotus 5 speed and turned around 4 speed mount, shows
the block to be slanted too much downward at the rear.
So, if someone could take a measurement as shown in the pic, I'd appreciate it.