Rear output drive shaft

PostPost by: Hawksfield » Tue May 03, 2016 5:38 pm

Hi all

Can anyone advise me of the size and thread type of the above drive shaft

Thanks in anticipation
John

+2s130 1971
User avatar
Hawksfield
Fourth Gear
Fourth Gear
 
Posts: 600
Joined: 14 Jul 2004

PostPost by: CBUEB1771 » Tue May 03, 2016 8:11 pm

If you are referring to the thread at the end of the outboard drive shaft, for attachment of the hub to the shaft, it is 3/4"-16 UNF.
Russ Newton
Elan +2S (1971)
Elite S2 (1962)
User avatar
CBUEB1771
Coveted Fifth Gear
Coveted Fifth Gear
 
Posts: 1684
Joined: 09 Nov 2006

PostPost by: Hawksfield » Wed May 04, 2016 1:34 pm

Russ

That's correct thanks
John

+2s130 1971
User avatar
Hawksfield
Fourth Gear
Fourth Gear
 
Posts: 600
Joined: 14 Jul 2004

PostPost by: Hawksfield » Mon May 09, 2016 6:46 pm

Russ

Pulled the output drive shaft and its 5/8" unf-18 so the die nut I bought is surplus to requirements
my fault for not checking myself. :evil:
John

+2s130 1971
User avatar
Hawksfield
Fourth Gear
Fourth Gear
 
Posts: 600
Joined: 14 Jul 2004

Total Online:

Users browsing this forum: No registered users and 13 guests