Sinking clutch pedal

PostPost by: mbell » Wed May 27, 2015 6:30 pm

I had to swap out the master cylinder on my car as the brakes were sticking on and turned out to have a 7/8" master!

To get the pedal box out I removed the airbox and carbs but was still a tight fit.

Once i had it off the car a did the common mod of cutting an access hole in the top so you can disconnect and remove the masters with out needing to remove the pedal box or do the impossible pin removal from the foot well.
'73 +2 130/5 RHD, now on the road and very slowly rolling though a "restoration"
mbell
Coveted Fifth Gear
Coveted Fifth Gear
 
Posts: 2691
Joined: 07 Jun 2013
Previous

Total Online:

Users browsing this forum: No registered users and 17 guests