Page 1 of 1
Clutch fork attachments
Posted:
Wed Mar 12, 2014 6:42 pmby William2
I am about to reassemble the clutch fork and release bearing assembly and I believe this can be a bit tricky. I think the only thing I would appreciate clarification on are the 2 spring clips. One end of each clip is bent round in more of a circle than the other. Which end goes in the clutch fork and which in the release bearing carrier?
Re: Clutch fork attachments
Posted:
Wed Mar 12, 2014 6:58 pmby TroonSprint
I agree it is a bit muddling on first acquaintance, so I took a couple of photos. I hope they are a help.
Mike
Re: Clutch fork attachments
Posted:
Wed Mar 12, 2014 9:08 pmby john.p.clegg
The more curly bit goes into the bearing carrier,the less curly bit into the arm...
John
Re: Clutch fork attachments
Posted:
Thu Mar 13, 2014 9:03 amby William2
Thanks for your help gentlemen. You wouldn't want to get it wrong and everything to come apart with all the engine back in!
Re: Clutch fork attachments
Posted:
Thu Mar 13, 2014 9:14 amby john.p.clegg
Check for wear on the curly springs where they locate,mine were replaced last time I had the box out and now they're nearly worn through......cheap copies..shiny thin material...managed to get good replacements...thicker and darker.
John
Re: Clutch fork attachments
Posted:
Sun Mar 16, 2014 3:50 pmby CBUEB1771
The proper arrangement is also illustrated in the workshop manual.