Page 1 of 1

Differential Torque Rod Washers

PostPosted: Sat Aug 10, 2013 1:45 pm
by AlfaLofa
The sequence for attaching the torque rods to the diff is:

. Fixed washer on rod
. Bush
. Cup Washer with large hole
. Diff Lug
. Cup Washer with large hole
. Bush
. Cup Washer with small hole
. Nyloc Nut

However the last two sets of bushes/washers I have purchased (from the usual suppliers) have been supplied with only one variety of cup washer - that with the large hole.

Does any one know a source for the small hole variety?

Re: Differential Torque Rod Washers

PostPosted: Sat Aug 10, 2013 2:11 pm
by robertverhey
I used shock absorber top washers. Steve lists suitable washers at sj spares, see last two items in list at http://www.sjsportscars.co.uk/index.php?mod=10

Re: Differential Torque Rod Washers

PostPosted: Sat Aug 10, 2013 3:21 pm
by john.p.clegg
...if only someone would produce these washers in stainless (diff tie rod / anti roll bar )...

John

Re: Differential Torque Rod Washers

PostPosted: Sat Aug 10, 2013 4:07 pm
by AlfaLofa
Robert - thanks for that.

Re: Differential Torque Rod Washers

PostPosted: Mon Aug 12, 2013 4:17 pm
by Jeff@Jae
We have both flavors of those washers in stock.

Re: Differential Torque Rod Washers

PostPosted: Mon Aug 12, 2013 6:20 pm
by john.p.clegg
I take it that means the two sizes not mild/stainless steel?

John :wink: