4 speed gearbox input shaft dimensions
Posted: Mon Sep 05, 2011 8:18 am
Hi
Lots of apologies for asking this (again!) but- I just wanted to make sure my info was exactly right before going any further and I know somebody has supplied some of this info before
If somebody out there has a handy 4 speed box could they confirm the following measurements (or challenge them)-
Distance from front face of box (without the bellhousing fitted) to start of splines- 100 mm
Spline length-43mm
Distance from end of splines ie nose end to end of shaft- 32mm
Plus (asking a lot I know) if somebody has a std 4 speed clutch friction disc could they measure the length of the splined section.
Many thanks
John
Lots of apologies for asking this (again!) but- I just wanted to make sure my info was exactly right before going any further and I know somebody has supplied some of this info before
If somebody out there has a handy 4 speed box could they confirm the following measurements (or challenge them)-
Distance from front face of box (without the bellhousing fitted) to start of splines- 100 mm
Spline length-43mm
Distance from end of splines ie nose end to end of shaft- 32mm
Plus (asking a lot I know) if somebody has a std 4 speed clutch friction disc could they measure the length of the splined section.
Many thanks
John