front hub shaft wear
Posted: Fri Nov 12, 2010 9:10 pm
Hi,
Can any one advise me on the amount of tolerable wear on the front hub shafts were the inner races run on the shaft. I know that the bearing is the main surface but I have noticed (on other cars) that when you look at the shafts there is some wear on the bottom side. It is were the outer and inner bearings (inner) races have shifted and have worn the area. Weight of car!
It is not as bad as some I have seen (and replaced) were you could run your finger nail against a lip. It appears to be about 1.0 to 1.5 thou less over all when using a vernier.
Will it manifest itself as play as the bearing has a larger gap on the shaft?
PS on a Plus 2S
Thanks Mike
Can any one advise me on the amount of tolerable wear on the front hub shafts were the inner races run on the shaft. I know that the bearing is the main surface but I have noticed (on other cars) that when you look at the shafts there is some wear on the bottom side. It is were the outer and inner bearings (inner) races have shifted and have worn the area. Weight of car!
It is not as bad as some I have seen (and replaced) were you could run your finger nail against a lip. It appears to be about 1.0 to 1.5 thou less over all when using a vernier.
Will it manifest itself as play as the bearing has a larger gap on the shaft?
PS on a Plus 2S
Thanks Mike