Adjusting clutch
Posted: Thu Nov 11, 2010 8:11 pm
Hi Folks
Just got the engine/gearbox on to the rolling chassis and set up the clutch with a temporary hand operated master cylinder to check it works OK. In making the 2mm gap adjustment. I assume you either remove the return spring and pull the operating arm back until small contact resistance is felt when the release bearing contacts the clutch cover spring operating plate. Or do the same with the spring on in which case a bit more force is required to take up the slack.
With the return spring on there wont be a 2mm gap
I assume I understand this correctly
thanks in advance for any comments
cheers
Bob
Just got the engine/gearbox on to the rolling chassis and set up the clutch with a temporary hand operated master cylinder to check it works OK. In making the 2mm gap adjustment. I assume you either remove the return spring and pull the operating arm back until small contact resistance is felt when the release bearing contacts the clutch cover spring operating plate. Or do the same with the spring on in which case a bit more force is required to take up the slack.
With the return spring on there wont be a 2mm gap
I assume I understand this correctly
thanks in advance for any comments
cheers
Bob