Page 3 of 3

Re: CV Driveshaft Conversion

PostPosted: Sat Sep 18, 2010 12:28 pm
by 512BB
Terry, sing up mate, I cant HEAR you.

John, great to meet you the other week, enjoyed the chat. I get the car over the pit on a very regular basis, and pull the car over my head to observe the donuts whilst they are rotating, looking for any nasties in that department. That way, I hope to eliminate any slaps on the back. My job offer still stands at any time, by the way.

All the best,

Leslie

Re: CV Driveshaft Conversion

PostPosted: Sat Sep 18, 2010 2:16 pm
by terryp
Leslie
I have a feeling "whole lot of klonkin goin on" is on the same album as

I hear you Clonkin
Clonkin on heavens door
Just like a Clonkin
The times , they are a clonkin
Clonkin in the wind

and who could forget
Don't think twice , its all clonkin!

Terry
PS I don't have a clonk as such!

Re: CV Driveshaft Conversion

PostPosted: Wed Sep 22, 2010 2:51 pm
by Famous Frank
I have a set of CV joins and adapter plates. Can anyone tell me what the length of the cv joint axle is? Does anyone have a set from TTR or Sue Miller that is not yet assembled ad can giv me an axle length? This is not for a Plus 2. It is for a regular Elan. Thank you very much,

Frank

Re: CV Driveshaft Conversion

PostPosted: Wed Sep 22, 2010 9:51 pm
by robertverhey
Thanks I'd be keen to know this too....however the ideal length of axle will be dependent on the thickness of the adaptor plates, yes? I've been told 295mm for a 14mm plate.

robert