splined shafts

PostPost by: rdssdi » Wed Sep 30, 2009 10:20 pm

When assembling a fixed splined shaft into a splined hub flange should I use a copper anti seize?

It is a splined fit with no key or taper.

Bob
rdssdi
Coveted Fifth Gear
Coveted Fifth Gear
 
Posts: 1426
Joined: 30 Sep 2003

PostPost by: rgh0 » Thu Oct 01, 2009 10:40 am

Depends on operating temperature and environment. IF not to hot or to heavily loaded I would use loctite. i would use an anti sieze if operating above loctite melt temperatures or load stresses above what loctite can carry.

cheers
Rohan
User avatar
rgh0
Coveted Fifth Gear
Coveted Fifth Gear
 
Posts: 8814
Joined: 22 Sep 2003

Total Online:

Users browsing this forum: No registered users and 9 guests