Depth of 4 speed bellhousing
2 posts
• Page 1 of 1
Post by: worzel » Wed Jan 04, 2012 9:17 pm
Hi
Lots of apologies for asking this again but I've lost the info.
Can any obliging owner let me know how deep the cast iron bellhousing is for a four speed elan plus-if possible-
how far the input shaft protrudes from the front of the four speed box (160mm I think from memory)
how far from the front case of the box the splines begin (85mm from memory)
how long the splined section is (I assume it's the same as a Type 9 ie 43mm)
Many thanks for your trouble.
John
Lots of apologies for asking this again but I've lost the info.
Can any obliging owner let me know how deep the cast iron bellhousing is for a four speed elan plus-if possible-
how far the input shaft protrudes from the front of the four speed box (160mm I think from memory)
how far from the front case of the box the splines begin (85mm from memory)
how long the splined section is (I assume it's the same as a Type 9 ie 43mm)
Many thanks for your trouble.
John
- worzel
- Fourth Gear
- Posts: 614
- Joined: 13 Jan 2004
Post by: john.p.clegg » Thu Jan 05, 2012 9:50 am
-
john.p.clegg - Coveted Fifth Gear
- Posts: 4533
- Joined: 21 Sep 2003
2 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 29 guests
Site map
SitemapIndex
RSS Feed