early plus 2 arm rest lid
Posted: Fri May 29, 2020 4:24 am
Thanks to Frank I am now fitting the centre consol but first must attach the lid which was
donated by a wonderful fellow forum member!
It hinges from a raised area towards the rear of the consol and slightly overlaps the tray at the front.
However, if the hinge is bolted to the consol the lid, when opened it will put strain on the hinge area
unless limited in how far up it can go.
I can see no obvious way to limit its opening to avoid that and I do not recall the problem on my earlier Plus 2.
A spacer between the hinge and the consol will not work.
All I can thing of is to attach a short strop to the aluminium base and to attach the other end, with suitable
backing, under the console, in each case perhaps a couple of inched forward of the hinge.
Any other ideas?
Regards
Bill
donated by a wonderful fellow forum member!
It hinges from a raised area towards the rear of the consol and slightly overlaps the tray at the front.
However, if the hinge is bolted to the consol the lid, when opened it will put strain on the hinge area
unless limited in how far up it can go.
I can see no obvious way to limit its opening to avoid that and I do not recall the problem on my earlier Plus 2.
A spacer between the hinge and the consol will not work.
All I can thing of is to attach a short strop to the aluminium base and to attach the other end, with suitable
backing, under the console, in each case perhaps a couple of inched forward of the hinge.
Any other ideas?
Regards
Bill