dashbaord fitting
Posted: Fri Jul 05, 2019 9:11 am
hallo all Elan People!
I'm in trouble to fit the dashboard!
the side holes are ok against the thread of the body
the bottom holes around the tunnel are nearly against the holes of the bottom cross profile of the V-bracket of the heater
the two top holes around the chocke/heater cables are 15 mm away! damn?!?!?!
If I push these top holes a bit the wooden board bend too much having the two L-bracket on the bottom edge of the heater that are the limit
question:
1) do I make a wooden spacer to close the top gap between the top edge of the board and the bottom crash pad edge?
2) no spacer at all just the bushes of the screws
2) do I shorten the L-brackets (... but the spade&connectors of the button could crash into the heater!)
3) do I slot the holes of the V-bracket and move it backward few mm (but it's not enough there is still a gap on the top! )
thanks for the help
Ciao a Tutti Paolo
I'm in trouble to fit the dashboard!
the side holes are ok against the thread of the body
the bottom holes around the tunnel are nearly against the holes of the bottom cross profile of the V-bracket of the heater
the two top holes around the chocke/heater cables are 15 mm away! damn?!?!?!
If I push these top holes a bit the wooden board bend too much having the two L-bracket on the bottom edge of the heater that are the limit
question:
1) do I make a wooden spacer to close the top gap between the top edge of the board and the bottom crash pad edge?
2) no spacer at all just the bushes of the screws
2) do I shorten the L-brackets (... but the spade&connectors of the button could crash into the heater!)
3) do I slot the holes of the V-bracket and move it backward few mm (but it's not enough there is still a gap on the top! )
thanks for the help
Ciao a Tutti Paolo