Page 1 of 1
Failsafe vacuum pod
Posted:
Tue Nov 27, 2018 5:48 pm
by el torro
Is there an easy/safe way to get springs off it,going to convert to electric system
Re: Failsafe vacuum pod
Posted:
Tue Nov 27, 2018 10:30 pm
by gus
Headlights up
grill out
chunk of plywood or something to stop the spring from shooting through the nose
remove the nut
decide which hand is sacrificial and put it between the plywood and the spring and slide the spring of the bolt
not really that bad
Re: Failsafe vacuum pod
Posted:
Tue Nov 27, 2018 10:54 pm
by elated
With that clarity of expression brace yourself for Haynes beating a path to your door.
Gordon
Re: Failsafe vacuum pod
Posted:
Wed Nov 28, 2018 12:07 am
by el torro
Good advice,I have some thick carpet also to be sure,I am right handed so will use left hand just in case, only bit I did was grill out a bast...? To put back I seem to remember and headlights up they only stay down for about 5 hours this is what caused car cover to come off at front in wind,going to do mod with Mazda headlamp motor on forum, need to find out if I use right hand side motor or left decisions decisions
Re: Failsafe vacuum pod
Posted:
Wed Nov 28, 2018 8:15 pm
by Bigbaldybloke
You can use either Mazda motor, just depends on which way you want the manual knob to point. With bonnet off and grill out access is not too bad and with the headlamp pods up the spring is not under too much force. I refitted both springs when I fitted the Mazda motor to minimise the load on the motor, one to each pod. Needs a good strong motor mount as the motor is quite heavy and gets a good shaking around. Mind your fingers when setting up the motor linkage, it?s fast and powerful and if the springs don?t get you, it will and it?s much nastier than the springs!
Re: Failsafe vacuum pod
Posted:
Wed Nov 28, 2018 11:22 pm
by el torro
Thanks for info all I need now is a dry day and my brain cell to be in gear,think I will get an assistant who's back is in better condition than mine
Re: Failsafe vacuum pod
Posted:
Thu Nov 29, 2018 10:34 am
by Bigbaldybloke
In Edinburgh that will be around Easter then
Re: Failsafe vacuum pod
Posted:
Thu Nov 29, 2018 4:10 pm
by el torro
By Easter ,that's optimistic,we will exporting it soon we are full up
Re: Failsafe vacuum pod
Posted:
Thu Nov 29, 2018 8:21 pm
by Lotus14S2
O.K., What i read is this is not about a vacuum pod, but is about converting the headlight pods to electricity.
Is there an article somewhere about converting the vacuum system to electricity?
If so is the system for the early double pod, or the later single pod system?
Thanks for your help.
Tim
'63 S1 Elan
'62 S2 Elite
Re: Failsafe vacuum pod
Posted:
Fri Nov 30, 2018 12:03 am
by Bigbaldybloke
look In the Technical Mods section, there is currently a discussion going on about using Mazda electric motors. Scroll through this topic and there are links to detailed descriptions on this conversion
Re: Failsafe vacuum pod
Posted:
Fri Nov 30, 2018 1:56 am
by Lotus14S2
Thanks for your note
Tim