Page 1 of 1
Door Seal Finish
Posted:
Wed Jan 10, 2018 2:00 amby Terry Posma
Can anyone advise how the door seals are finished at the end cap which sits under the hood cover on an S3?
I would think the seal would be squeezed under the cap but there does not appear to be sufficient room. Photos of original would be appreciated.
Cheers.
Re: Door Seal Finish
Posted:
Wed Jan 10, 2018 1:32 pmby MarkDa
I slit mine to allow the seal itself past.
I suspect that's not correct though
Re: Door Seal Finish
Posted:
Wed Jan 10, 2018 6:47 pmby holywood3645
Im not sure if this is the part you are referring to. If it is, I got these from RD in the US
James
Re: Door Seal Finish
Posted:
Wed Jan 10, 2018 7:53 pmby gjz30075
What James shows is correct for S3 onward, per the Parts manual..
Re: Door Seal Finish
Posted:
Thu Jan 11, 2018 2:45 amby Terry Posma
James,
That is exactly what I was looking for.
I am not sure how the whole lot is going to fit but that is another question.
Cheers.
Re: Door Seal Finish
Posted:
Thu Jan 11, 2018 4:55 amby holywood3645
It?s pretty simple push fit then gets locked in place with aluminum strip when it?s secured
James
Re: Door Seal Finish
Posted:
Thu Jan 11, 2018 4:55 amby holywood3645
It?s pretty simple push fit then gets locked in place with aluminum strip when it?s secured
James