Page 1 of 1

Holes in bulkhead - still uncertain of pupose

PostPosted: Fri Jul 14, 2017 5:51 pm
by bloodknock
fullsizeoutput_1cca.jpeg and
Drawing of hole queries
Hello Lotus Blosoms
I'm afraid to say im still uncertain and i really want to get this right. Ive owned this car since 1972, and im sure that no extra holes have ever been cut in the bulkhead. I'm now reassembling the little bugger and need to get this sorted.
I have drawn a sketch of the bulkhead highlighting what I think is correct and those i'm uncertain about....they are marked ABCDE and F
Can anyone with an intact original car please advise me?
thanks and regards
Bob

Re: Holes in bulkhead - still uncertain of pupose

PostPosted: Fri Jul 14, 2017 7:15 pm
by richardcox_lotus
From memory;

D is handbrake cable.
I think you are missing a hole for the throttle cable - it's on the horizontal surface above the drivers footwell near the vertical firewall corner.

I'll try and get photos for the rest later

Regards
Richard
'72 sprint

Re: Holes in bulkhead - still uncertain of pupose

PostPosted: Fri Jul 14, 2017 7:38 pm
by Grizzly
dsc04118.jpg and

White = Choke cable
Yellow = Handbrake Bracket
Purple = Speedo
Green = Steering column Bracket
Orange = Oil Pressure gauge tube
Blue ?????

D = Handbrake cable
E = Heater hot/cold control cable
F is eluding me just at the moment.

From memory so don't be shocked if i have two mixed up but i think thats right....... as above your missing your Handbrake mount hole and Throttle cable hole in the horizontal surface, also should have another headlight Vac hold next to the one you have labelled in your picture.
p1040332.jpg and


I noticed you have the hole marked as Heater control is Temp gauge and the one marked Temp gauge is Washer pipe.

Re: Holes in bulkhead - still uncertain of pupose

PostPosted: Fri Jul 14, 2017 8:12 pm
by richardcox_lotus
Grizzly you snuck in there.....

This is what I have:

A is speedo cable
B is choke cable
C is oil pressure cable
D is handbrake cable
E is my heater control cable
F is a blanking plug
On my car the washers are above the temp gauge

One photo below is of throttle cable and handbrake handle securing nut

The second is of the washer and temp gauge

Another is of my vacuum pipes - you see I have 2, one above the other.

It's a Sprint with Weber's that was repainted 4 years ago by Miles Wilkins - and that was the1st time it had been apart since it was built.

Hope this helps

img_5108.jpg and
img_5107.jpg and
img_5103.jpg and

Richard

Re: Holes in bulkhead - still uncertain of pupose

PostPosted: Fri Jul 14, 2017 8:28 pm
by richardcox_lotus
Looking again Bob, your 'A' is probably for the bonnet bracket nut.

Re: Holes in bulkhead - still uncertain of pupose

PostPosted: Fri Jul 14, 2017 9:12 pm
by bloodknock
Richard, Chris,
youre aces, thanks very much gents.
looks as if I havent enough holes!
Bob