Elan window motor screws
5 posts
• Page 1 of 1
Post by: Kevin Sprint » Sat Jan 15, 2022 11:38 am
just changing my Elan Sprints window motor and screws from mounting plate to frame are in poor condition.
what thread are they as rusty and part stripped getting them out (frame threads are ok)
what thread are they as rusty and part stripped getting them out (frame threads are ok)
- Kevin Sprint
- New-tral
- Posts: 3
- Joined: 15 Jan 2022
Post by: smo17003 » Sat Jan 15, 2022 5:16 pm
Screws are 1/4" UNF x 1/2" long.
If you use WIKI (at the top of the page) you can access the parts drawings. Also look at Intro - Standard Hardware, it shows you how to decipher the Lotus part numbering.
Mike
If you use WIKI (at the top of the page) you can access the parts drawings. Also look at Intro - Standard Hardware, it shows you how to decipher the Lotus part numbering.
Mike
Mike
1967 S3 FHC
1968 S4 FHC
1967 S3 FHC
1968 S4 FHC
- smo17003
- Third Gear
- Posts: 393
- Joined: 11 May 2006
Post by: Kevin Sprint » Mon Jan 17, 2022 6:05 pm
Hi Mike
thanks very much as top rh screw awkward to start I may put a stud in and fit a nut & washer.
Kev.
thanks very much as top rh screw awkward to start I may put a stud in and fit a nut & washer.
Kev.
- Kevin Sprint
- New-tral
- Posts: 3
- Joined: 15 Jan 2022
Post by: Kevin Sprint » Mon Jan 17, 2022 8:51 pm
sounds good thanks
- Kevin Sprint
- New-tral
- Posts: 3
- Joined: 15 Jan 2022
5 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 24 guests
Site map
SitemapIndex
RSS Feed