Page 1 of 1

Bleeding clutch on Zetec Elan (MT 75 box)

PostPosted: Wed Mar 11, 2015 10:12 pm
by Stratosboy
I am at the stage of needing to fill hydraulics systems, on my Spyder Zetec Elan. The brakes are straight forward, but not clear how I bleed clutch on this gearbox. I believe it is a Ford Scorpio MT 75 box with hydraulic clutch (obviously) - slave cylinder is on inlet side of Zetec engine.
Any help out there? - is the bleed nipple underneath the rubber gaiter on the side of gearbox?
Thanks

Re: Bleeding clutch on Zetec Elan (MT 75 box)

PostPosted: Thu Mar 12, 2015 4:57 pm
by spyzee
It's on the other side of the gearbox and takes a little bit of finding. Mine bled perfectly first time, and again two years later when I had to replace the clutch master cylinder.

Re: Bleeding clutch on Zetec Elan (MT 75 box)

PostPosted: Thu Mar 12, 2015 5:39 pm
by Stratosboy
Cheers Spyzee, that's great I'll find it now.

Re: Bleeding clutch on Zetec Elan (MT 75 box)

PostPosted: Thu Mar 12, 2015 8:50 pm
by dougweall
Guess the wife is out in the Exige then Dave :lol:

Doug.

Re: Bleeding clutch on Zetec Elan (MT 75 box)

PostPosted: Thu Mar 12, 2015 10:45 pm
by spyzee
Here's a link with a bit better description:

http://forum.wscc.co.uk/forum/index.php ... -bleeding/

and I was advised by Spyder to change the 75 W90 oli and use ATF D3 fluid which is much lighter. This made a big difference to the gear change.

Colin

Re: Bleeding clutch on Zetec Elan (MT 75 box)

PostPosted: Sun Mar 22, 2015 5:39 am
by stugilmour
Here is a drawing from the manual showing the bleed tube (part 2). Mine seems to be a bit fiddled up as it is loosening at the tube threads rather than opening the bleeder. I have to attend to it properly this spring. Maybe see if you can get vice grips or similar on the tube while loosening the bleeder if you are unsure how tight it is?

HTH

Stu

PS Did you find the on-line copies of the MT75 service manuals for reference?

Re: Bleeding clutch on Zetec Elan (MT 75 box)

PostPosted: Sun Mar 22, 2015 6:19 pm
by Stratosboy
thanks for this stugilmour,
I have found the pdf files for the MT75 box, but mine seems to be the opposite configuration to how it's depicted in the diagram, the feed from the master cylinder is on the side where the bleed tube is in the diagram.
I'll sort it out...!