Advice needed re: Zetec fuel injection system
Posted: Mon Nov 17, 2014 8:21 pm
I wonder if anyone can could give me some more advice? I'm at the stage of plumbing in the fuel system, filters pump etc. How did others do theirs? - do you have any pics you could share. I'm using a mid-mounted tank sitting between chassis uprights.
I'm a bit confused as I have 4 outlets from the tank, I suspect the large bore one on the top left is the fuel return, the large bore at the bottom is for the feed to the first filter - pre pump, I'm adding a second filter after the pump.
I have a small outlet top right, which I suspect is a breather. But also have another one midway up front of tank. Do you think this would be another return from a swirl tank? - if so could I just seal this as tank has swirl chamber built in?
Where do people recommend for fuel unions? - need a couple of M16 x1.5 with 8mm outlet
Thanks for any advice you can give.
I'm a bit confused as I have 4 outlets from the tank, I suspect the large bore one on the top left is the fuel return, the large bore at the bottom is for the feed to the first filter - pre pump, I'm adding a second filter after the pump.
I have a small outlet top right, which I suspect is a breather. But also have another one midway up front of tank. Do you think this would be another return from a swirl tank? - if so could I just seal this as tank has swirl chamber built in?
Where do people recommend for fuel unions? - need a couple of M16 x1.5 with 8mm outlet
Thanks for any advice you can give.