connectors for crank position sensor
Posted: Sun Mar 04, 2012 2:33 pm
Hi Folks
As part of my rebuild I am fitting Engine Management on my December 1973 Lotus Elan +2S130
I have sourced all the parts and have got all the required connectors for the electrics except for 1.
I need to get hold of a connector for the Crank Position Sensor. The one I have ( I believe) is from a Rover MGF models up VIN YD522572. The sensor itself has a part number NSC100390 and is referred to in the MG Rover Parts list as a
Crank Sensor Engine Lucas Long Pin 1. Picture attached below.
Welcome any ideas. Scrap yards ( around here) and Rover spares suppliers only want to sell complete looms bit excessive to cut a single connector off
Any suggestions on source of supply or any details on connectors such as what type R they would help.
regards
Bob
As part of my rebuild I am fitting Engine Management on my December 1973 Lotus Elan +2S130
I have sourced all the parts and have got all the required connectors for the electrics except for 1.
I need to get hold of a connector for the Crank Position Sensor. The one I have ( I believe) is from a Rover MGF models up VIN YD522572. The sensor itself has a part number NSC100390 and is referred to in the MG Rover Parts list as a
Crank Sensor Engine Lucas Long Pin 1. Picture attached below.
Welcome any ideas. Scrap yards ( around here) and Rover spares suppliers only want to sell complete looms bit excessive to cut a single connector off
Any suggestions on source of supply or any details on connectors such as what type R they would help.
regards
Bob