Manifold “Y” piece and Centre pipe orientation
5 posts
• Page 1 of 1
Post by: bloodknock » Thu Aug 22, 2024 11:36 am
Hello people,
I want to get this correct…
The manifold Y piece has a horizontal bias, should the outlet bias upwards or downwards?
The centre pipe has a 15degree bend at one end, should this be at the front of the car or rear, and viewing from the top down should it go to the left or right?
Thanks Bob
I want to get this correct…
The manifold Y piece has a horizontal bias, should the outlet bias upwards or downwards?
The centre pipe has a 15degree bend at one end, should this be at the front of the car or rear, and viewing from the top down should it go to the left or right?
Thanks Bob
I've got a deadline, at 73, I want to finish it before I die!
-
bloodknock - Fourth Gear
- Posts: 609
- Joined: 04 Jun 2012
- Location: Colwyn Bay, North Wales
Post by: gjz30075 » Thu Aug 22, 2024 3:08 pm
The 15 degree bend goes at the front of the car and pointed to the left.
Greg Z
45/0243K Sprint
45/7286 S3 SE DHC
45/0243K Sprint
45/7286 S3 SE DHC
-
gjz30075 - Coveted Fifth Gear
- Posts: 3594
- Joined: 12 Sep 2003
- Location: Roswell, Georgia, USA
Post by: bloodknock » Tue Aug 27, 2024 11:12 am
The Y piece has a slight bias
Should the outlet be biased up or down?
Should the outlet be biased up or down?
I've got a deadline, at 73, I want to finish it before I die!
-
bloodknock - Fourth Gear
- Posts: 609
- Joined: 04 Jun 2012
- Location: Colwyn Bay, North Wales
- smo17003
- Third Gear
- Posts: 394
- Joined: 11 May 2006
- Location: Oxford, England
Post by: bloodknock » Fri Aug 30, 2024 3:55 pm
This is my Y piece , see the bias, should the front be up or down?
- Attachments
-
-
I've got a deadline, at 73, I want to finish it before I die!
-
bloodknock - Fourth Gear
- Posts: 609
- Joined: 04 Jun 2012
- Location: Colwyn Bay, North Wales
5 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 9 guests
Site map
SitemapIndex
RSS Feed