Elan S4 Dash Harness
Posted: Thu Sep 08, 2022 3:09 pm
I bought a new harness for my S4 Elan from a well-known manufacturer.
I started with sorting out all the connections on the dashboard.
All the cables line up with the switches and instrumentation apart from the 3 wires needed to connect to the Heater Motor switch. (I have it labelled as Fan switch)
The Green/Yellow & one of the Green wires are there but about 14" away from where it should be.
I am not an electrical engineer, and this is my first attempt, so I might be doing something wrong, but everything else fits as I expected. On the attached photo I have circled where the cables are and an arrow showing the switch they need to connect to.
I have been in contact with the manufacturer and sent loads of pictures and, despite clearly seeing that the wires are in the wrong place,(I think) says that the loom was made correctly to the pattern.
I am asking if anyone on the forum has experience of something similar.
I started with sorting out all the connections on the dashboard.
All the cables line up with the switches and instrumentation apart from the 3 wires needed to connect to the Heater Motor switch. (I have it labelled as Fan switch)
The Green/Yellow & one of the Green wires are there but about 14" away from where it should be.
I am not an electrical engineer, and this is my first attempt, so I might be doing something wrong, but everything else fits as I expected. On the attached photo I have circled where the cables are and an arrow showing the switch they need to connect to.
I have been in contact with the manufacturer and sent loads of pictures and, despite clearly seeing that the wires are in the wrong place,(I think) says that the loom was made correctly to the pattern.
I am asking if anyone on the forum has experience of something similar.