Page 1 of 1
Spit and polish
Posted:
Mon Jul 10, 2017 8:30 pm
by shaun
After a bit of cleaning and rebuild pleased with these
Re: Spit and polish
Posted:
Mon Jul 10, 2017 8:32 pm
by pharriso
Very nice, I need to do the same. Ultrasonic cleaner?
Re: Spit and polish
Posted:
Mon Jul 10, 2017 8:40 pm
by Grizzly
Vapour blasted?
I was paranoid about getting the beads inside so i had mine Soda blasted then Ultrasonic cleaned, i didn't get the semi gloss look of Vapour blasting but still looked like new.
Re: Spit and polish
Posted:
Mon Jul 10, 2017 9:09 pm
by richardcox_lotus
Look great. I've never seen those kind of top cover fixings on a Weber before.
Regards
Richard
Re: Spit and polish
Posted:
Tue Jul 11, 2017 8:41 am
by shaun
Fixings just temporary while waiting for correct ones
Re: Spit and polish
Posted:
Wed Jul 12, 2017 9:45 am
by TeeJay
What a transformation, good job, well done.
Re: Spit and polish
Posted:
Thu Jul 13, 2017 8:05 am
by rady32md
Looks really clean. May I know the steps you did to make them look good again.
Re: Spit and polish
Posted:
Thu Jul 13, 2017 12:14 pm
by shaun
The carbs underwent a complete strip down , the bodies tops etc were then cleaned in decarboniser then taken for vapour blasting. All mild steel items were bead blasted and zinc coated , the jets etc were ultrasonic cl leaned , shaft checked for straightness then all reffitted with new bearings and gaskets etc . The pictures show temporary top screws , waiting for originals to come back from platers I was quoted ?39 for complete new set thanks but no thanks