Page 1 of 1

harness for Hoinsting motor

PostPosted: Thu Feb 23, 2006 5:04 pm
by foggy
You guys with too much experience pulling motors probably have a best
harness design and attachment points to motor for pulling motor...
1. and trans as a unit from the bare frame
2. and trans from assembled (body on) car
3. only from frame only
4. from assembled car.

Might you share your wisdom???
Thanks
Steve

harness for Hoinsting motor

PostPosted: Thu Feb 23, 2006 6:15 pm
by triumphelan
You need to remove first the engine thenthe gearbox ,I don`t think it can be done anyother way ,I have been wrong before [1991 it was ]
Regards John 1969 S4 dhc
----- Original Message -----
From: foggyalfa
To: ***@***.***
Sent: Thursday, February 23, 2006 5:04 PM
Subject: [LotusElan.net] harness for Hoinsting motor


You guys with too much experience pulling motors probably have a best
harness design and attachment points to motor for pulling motor...
1. and trans as a unit from the bare frame
2. and trans from assembled (body on) car
3. only from frame only
4. from assembled car.

Might you share your wisdom???
Thanks
Steve











SPONSORED LINKS Plus Sprint Devoted
Impressions


------------------------------------------------------------------------------


a.. Visit your group "lotuselan" on the web.

b.. To unsubscribe from this group, send an email to:
***@***.***

c.. .


------------------------------------------------------------------------------