Outer drive shaft, inner bearing
3 posts
• Page 1 of 1
I have just replaced mine, and still have it in the garage. I'll measure
it tomorrow lrt you know.
Jeff 72+2
david_cusworth wrote:
it tomorrow lrt you know.
Jeff 72+2
david_cusworth wrote:
-
jeff jackson - Fourth Gear
- Posts: 578
- Joined: 31 May 2004
The Type 18 Inner bearing is ~20mm or 3/4" wide. Just measure the distance from the shoulder to the snap ring groove. If it's less than that, you have the early version.
Stan
I have an outer drive shaft, inner bearing in front of me and I don't
know if it is the early, or later (issue 18) type. Has anyone got one
to hand they can measure, so I can confirm which this is?
Thanks,
David
Stan
I have an outer drive shaft, inner bearing in front of me and I don't
know if it is the early, or later (issue 18) type. Has anyone got one
to hand they can measure, so I can confirm which this is?
Thanks,
David
- saarhus
- Third Gear
- Posts: 468
- Joined: 12 Oct 2003
3 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 20 guests