Plus2 roll cage
Posted: Sun May 02, 2010 11:32 am
Can any of you guys advise me regarding approved spec for a roll cage that I am building for my plus2, specifically the pipe dia ,wall thickness, steel type; I might as well try and get it right first time!
Had a bit of a look round on the 'net, it would appear that the main frame is 45-50mm, the wall thickness is 2.5mm (12g) and it can either be cold drawn steel or t45, if the latter, then it can be thinner tube; any input would be appreciated.
Had a bit of a look round on the 'net, it would appear that the main frame is 45-50mm, the wall thickness is 2.5mm (12g) and it can either be cold drawn steel or t45, if the latter, then it can be thinner tube; any input would be appreciated.